The total brightness measurements of the flood lights shown on this site are given in lumens. The definition of the lumen is based upon the sensitivity of the human eye, and is the best measure of how well a light can illuminate a given area. Lumen measurements take into account the total amount of light produced by the fixture, regardless of whether it is focused into a narrow beam or spread across a wide area. Lumens are a much better measurement to use than watts, which are a measure of electrical power, because different kinds of lights produce more or less lumens for a given amount of electricity. For example, a typical 55 watt halogen light produces about 600 lumens of light. An LED fixture that produces 600 lumens will typically only use about 10 watts of electricity.

The flood light brightness and electrical tests shown on this site are performed in a state-of-the-art optical laboratory using properly calibrated instruments. The measurements are done in accordance with procedures developed by the Illuminating Engineering Society of North America (the IES). Specifically, the 2 Pi procedure of IES Method LM-79-08. The equipment used is a 1 meter LabSphere Illumia integrating sphere with a CDS-610 spectrophotometer. The sphere is calibrated weekly against a NIST traceable calibration lamp. Simultaneous electrical and thermal measurements are made with calibrated, high accuracy laboratory instruments.

Image capture
All photos have been taken in the same conditions using the same equipment, to insure accuracy and consistency. Below are some more details:

Camera: Nikon D7100
Lens: Nikon DX SWM VR ED IF Aspherical ΓΈ72
Shutter speed: 1/20 S
F Stop: 10
Light distance to wall: 1 meter
Camera Distance to wall: 2 meters

Pricing
All prices are taken from the average market price at time of purchase.

Purchase dates
Date of purchase for each light varies, as detailed below:

Lumitec Cayman Superwhite:
Lumitec CapreraLT:
Rigid M Series Dually: 9/23/2014Lumitec Caprera2:
Dr. LED Kevin X4: 9/2/2014
Scandvik LED Spreader: 9/2/2014
Lumitec Cayman:
Rigid SR-Q:
Rigid M Series 6″ Spot: 9/23/2014
Dr. LED Kevin Jr. X2: 9/2/2014
Hella Mega Beam: 9/2/2014
Hella Sea Hawk: 9/2/2014

Testing location
All testing was done in Lumitec’s in-house optics lab. Lumens were measured using a Labsphere integrating sphere, taken at 1 minute after startup.